How to install windows xp from usb boot

I was checking constantly this blog and I am impressed! I was seeking this certain info for a very long time. Thank you and good luck. How i can solve the problem. The error message is FlashBoot utility is useful for this task. It automates everything. Need advise. I am installing it to an Acer laptop z model. Name required. Mail will not be published required. This option is usually found under the boot sequence menu of the BIOS. Filed under: How To's Tags: boot from usb , flash drive , format windows xp from flash drive , install os , install xp , komku , make bootable flash drive , usb , windows xp on flash drive December 3, by: Prasanth Chandra.

Nellie says:. December 13, at am. Install os using pendrive or memory card says:. September 5, at pm. March 31, at am. Kirk PCgenius Campbell says:. October 24, at am. August 25, at pm. August 9, at pm. Roel says:. April 25, at am. January 27, at am.

Instructions for doing so vary wildly from system to system, but generally entail the following:. Hotkey instructions are generally provided on the screen. Assuming that it is supported as is the case with virtually all modern hardware , promote your USB drive to the primary boot device. Please notice that you can seriously screw up your system by providing incorrect BIOS settings!

Depending on the speed of your USB drive, this may take a while. Is the USB device listed and does it have top priority? Have you correctly prepared the USB drive in step one? Restart the procedure. Does your USB drive properly support being booted from? Try another one! Step 4: Prepping the Hard Disk. You need to make sure that your hard drive is partitioned and formatted properly. Especially if you've had Linux or some other operating system on it, you'll need to repartition and format it.

The rescue drive contain file manager and command line utility. You can launch DiskPart for disk partitioning and formatting from the command utility. If you are sure that your hard drive is set up properly i. If your hard drive is partitioned in GPT mode, you also need repartition and format the disc. Enter the commands needed to repartition and format your drive. For example, try the following:. On your computer, disk 0 may not be the correct disk, you can use "list disk" to find the correct disk.

With your drive all ready, you can now launch the Windows XP setup with a few custom parameters. Remember that all USB devices will need to be plugged in right from the start while using the rescue drive. Replace C: with the drive you want to install Windows to. Proceed with the installation. The setup program will then silently close, which might make you think that something went wrong. Don't worry though. Note: The above guide works with Windows XP only.

Buy Now.